Siemens SINAMICS S120 - Interconnecting BICO Outputs

Fundamentals
3.3 BICO interconnections
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
67
3.3.3
Interconnecting BICO outputs
Use the connection dialog to connect binector or connector outputs.
Connecting a signal
To make a connection, proceed as follows:
1. Click the binector or connector icon of the signal that you want to connect (
or ).
A connection dialog for the selection of the possible parameters opens. The drive object
for which you want to make an interconnection is displayed automatically in the "Drive
object" drop-down list on the right.
Figure 3-4 BICO dialog output