Fundamentals
3.3 BICO interconnections
Commissioning with Startdrive
68 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
The last set signal sink is displayed in the "Selected sinks" field. If a connection was not
available previously, the text "No sink selected" is displayed.
2. Activate the check boxes for the parameters that you want to connect.
If connectable bits of the parameter are available, they are displayed in a drop-down list.
Figure 3-5 BICO dialog output: Parameter bits opened
3. Activate the check boxes for the parameter bits that you want to connect.
4. Confirm with OK.
The connection dialog closes.
The binector or connector output is connected to the selected parameter (bit).
To Next Page
Loading...
