Siemens SINAMICS S120 - Page 173

Commissioning
4.7 Basic parameterization of the drive objects
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
173
Define the offset (p0783)
The offset is applied additively to the signal to be output. The signal to be output can thus be
displayed within the measuring range.
1. Enter the required offset value in the "Offset" field for the relevant measuring socket.
Function diagrams (see SINAMICS S120/S150 List Manual)
•
8134
Diagnostics
- measuring sockets (T0, T1, T2)
Overview of important parameters (see SINAMICS S120/S150 List Manual)
Adjustable parameters
•
p0771[0...2]
CI: Measuring sockets signal source
•
p0777[0...2]
Measuring sockets ch
aracteristic curve value x1
•
p0778[0...2]
Measuring sockets characteristic curve value y1
•
p0779[0...2]
Measuring sockets characteristic curve value x2
•
p0780[0...2]
Measuring sockets characteristic curve value y2
•
p0783[0...2]
Measuring sockets offset
•
p0784[0...2]
Measuring sockets limitation on/off
Display parameters
•
r0772[0...2]
Measuring sockets signal to be output
•
r0774[0...2]
Measuring sockets output voltage
•
r0786[0...2]
Measuring sockets scaling per volt