Commissioning
4.7 Basic parameterization of the drive objects
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
195
Setting the calculation of the controller data
1. Select one of the following options for the calculation of the controller data in the
"Calculation controller data" (p0340) drop-down list:
– No calculation
The motor data is not calculated. This is the default setting.
– Complete calculation
The equivalent circuit diagram data is also calculated using the motor data.
– Calculation without equivalent circuit diagram data
The equivalent circuit diagram data entered during the parameter assignment of the
motor is not changed. The equivalent circuit diagram data is not calculated.
2. After the calculation type has been set (exception: "No calculation"), you can confirm the
calculation if this has not been done already (red status symbol).
To do this, click the "Confirm calculation" button.
The "Technology application" option is then disabled for the drive functions and the set
application can no longer be changed. The disable can be cancelled via the "Enable"
button. However, the calculation type must then be confirmed again.
To Next Page
Loading...
