Diagnostics
5.4 Fault and alarm messages
Commissioning with Startdrive
360 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
Note
The entry in the fault/alarm buffer is made after a delay. For this reason, the fault/alarm
buffer should not be read until a change in the buffer is also recognized (r0944,
r2121) after
"Fault active"/"Alarm active" is output.
Faults which occur are entered in the fault buffer as follows:
Figure 5-13 Structure of the fault buffer
To Next Page
Loading...
