Siemens SINAMICS S120 - Page 365

Diagnostics
5.4 Fault and alarm messages
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
365
External triggering messages
If the appropriate binector input is interconnected with an input signal, fault 1, 2 or 3 or alarm
1, 2 or 3 can be triggered via an external input signal.
Once an external fault (1 to 3) has been triggered on the Control Unit drive object, this fault
is also present on all associated drive objects. If one of these external faults is triggered on a
different drive object, it is only present on that particular drive object.
BI: p2106
––> External fault 1
––> F07860(A)
BI: p2107
––> External fault 2
––> F07861(A)
BI: p2108
––> External fault 3
––> F07862(A)
BI: p2112
––> External alarm 1
––> A07850(F)
BI: p2116 ––> External alarm 2 ––> A07851(F)
BI: p2117
––> External alarm 3
––> A07852(F)
Note
An external fault or alarm is triggered by a 1/0 signal.
An external fault and alarm do not usually mean that an internal drive message has been
generated. The cause of an external fault and warning should, therefore, b
e remedied
outside the drive.