Siemens SINAMICS S200 - Rotating the Connectors at the Motor

More information
For more information about cable requirements, see Section "Cables and connectors
(Page124)".
For more information about assembling cable terminals, see Section "Assembling cables
(Page734)".
6.5.5 Rotating the connectors at the motor
Overview
The connectors at the 1FL2 motor with shaft heights 45, 48, 52, 65, and 90 can be rotated to a
di󹪜erent angle to a limited extent.
Use a suitable socket connector as a lever to rotate the connector.
Note
Rotating the connect
ors
• Do not exceed the permissible range of rotation.
• To ensure the degree of protection, do not rotate more than 10 times.
WARNING
Adjusting cable directions
Bef
ore adjusting the cables, switc
h o󹪜 the power supply. Otherwise, the motor contains a
hazardous voltage and a risk of electric shock.
Connecting
6.5Connecting the motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 139