Siemens SINAMICS S200 - Testing the Converter Configuration

• "Limits"
– Torque and speed limits
The con
verter limit values are shown graphically and in a tabular form.
– "In-position" state
De󹪝ne the positioning window for the in-position monitoring function.
– Device supply voltage (only available for 400 V variants)
• "I/O con󹪝guration"
The con󹪝guration of the converter inputs and outputs is shown in a tabular form.
– In the table, a function can be assigned to an input or output of the terminal. Speci󹪝ed
functions can be selected.
– The analog inputs 0 and 1 have been de󹪝ned for speed limit and torque limit respectively
by default. The corresponding 󹪝elds are read-only.
– You can click the
icon to set the scaling and smoothing of functions assigned to the
analog inputs and outputs.
More information
For
more information about con󹪝guring setpoints, PTO, limits, and inputs/outputs, see Section
"Functions (Page225)"
7.4.2.3 Testing the converter con󹪝guration
Overview
After the quick setup, the web server allows you to test the converter con󹪝guration in jog mode
or continuous motion via the control panel.
Description of function
To test the con󹪝guration, the control panel must be open and the speed setpoint entered.
Commissioning (web server)
7.4Functions and menus
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
184 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA