Siemens SINAMICS S200 - Faults

Note:
Messages from encoders whose signal is no
t used for control purposes are output by the
converter as a warning.
11.3.2 Faults
Overview
A fault indicates that the reliable operation of the motor by the converter is at risk.
Description of function
Properties of faults
Faults have the following properties:
• Faults may cause the motor to be switched o󹪜.
• Faults must be acknowledged.
• Faults are displayed as follows:
– On the converter via the LEDs
– On the SINAMICS SDI Status panel via the 6-digit 7-segment display
– In the web server
You can 󹪝nd more information on the display of faults in Section "Messages (Page192)".
Acknowledge faults
You need to resolve the cause of the fault before you can acknowledge it.
To acknowledge a fault, you have the following options:
• Acknowledging via the OK button on the SINAMICS SDI Status panel
• Switching o󹪜 the converter power supply and switch on again
• Acknowledging via the web server
• The Safety Integrated fault is acknowledged by selecting and then deselecting the STO
function.
You can only acknowledge faults detected by the internal converter monitoring of hardware
and 󹪝rmware by switching the supply voltage o󹪜 and on again. In the list of faults, you will
󹪝nd the information on limitations when acknowledging at the corresponding fault codes.
More information
You can 󹪝nd more information on faults in Section "Overview of faults and alarms (Page320)".
System messages
11.3Faults and alarms
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 321