Siemens SINAMICS S200 - SDI Status Display

RDY COM Description Remedy
Orange
Converter detection via DCP 󹪞ashing -
Orange
Commissioning or restore factory settings via commission‐
ing tool
-
Table 11-3 Signal states of RDY and COM LEDs during 󹪝rm
w
ar
e updat
e
RD
Y COM Description Remedy
Green Green
Firmware update in progress -
Red
Firmware update signals an error.
• Switch the converter supply voltage
o󹪜 and on, and repeat the 󹪝rmw
are
update.
• Firmware update via memory card:
Replace memory card and repeat 󹪝rm‐
ware update.
• Contact Support/Hotline.
Green
Firmware update is completed.
The converter is w
aiting.
Switch the converter supply voltage o󹪜
and on.
Please contact Technical Support for LED states that are not described above.
11.1.3 SDI Status display
Descr
iption
Display Example Description Remarks
8.8.8.8.8.8.
Converter is in startup state -
Fxxxxx Fault code In the case of a single fault
F.xxxxx. Fault code of the 󹪝rst fault In the case of multiple faults
Fxxxxx. Fault code In the case of multiple faults
System messages
11.1SDI Status
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
316 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA