Siemens SINAMICS S200 - Basic Settings; Security Settings

7.3.3 Basic settings
Overview
Initial basic settings ar
e de󹪝ned in the function view.
Requirement
The web server is being called for the 󹪝rst time.
Description of function
The basic settings are as follows:
• Preferred language of the user interface
• Converter date and time
After these entries have been made, using the "Next" button, you can continue to the
Security Wizard.
7.3.4 Security settings
Overview
The Security Wizard o󹪜ers the following settings:
• User Management & Access Control (UMAC)
• Access to the integrated web server via the service interface with HTTP or HTTPS protocol
• Drive data encryption
Requirement
NOTICE
Data manipulation due to low protection
An inadequately
protected converter makes it easier for potential attackers to access the drive
data. Data manipulation can cause the drive to malfunction or damage it.
You can 󹪝nd information about the following actions on the Internet:Industrial Cybersecurity
Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/109810578).
• Only use the
low security settings in exceptional cases and only if an information security
risk analysis 󹪝nds that it is reasonable to do so.
• Con󹪝gure the settings for full protection immediately after adding a drive or several drives
to the project.
Commissioning (web server)
7.3Getting started
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
174 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA