Siemens SINAMICS S200 - Wiring of Pulse Train Outputs

6.8.2.6 Wiring of pulse train outputs
Overview
The converter supports high-speed 5 V di󹪜erential signals (A+/A-, B+/B-, Z+/Z-) and the open
collector (zero pulse).
Description
You can connect the pulse train outputs as shown below:
$POWFSUFS
;FSPNBSL
0QFODPMMFDUPS
3FDPNNFOE
ߘUPߘࣨ8
"QIBTFQVMTF
#QIBTFQVMTF
-PBE








.
150;
7
150;0$
.
7
150"
150"
150#
150#

* Connected to the reference ground of the PLC
Figure6-14 Wiring with the open collector
$POWFSUFS
"QIBTFQVMTF
#QIBTFQVMTF
;QIBTFQVMTF







150"
150"
.
150#
150#
150;
150;

* Connected to the reference ground of the PLC
Figure6-15 Wiring without the open collector
More information
For more information about the t
echnical data of pulse train outputs, see Section "General
technical data (Page504)".
Connecting
6.8Connecting the inputs and outputs
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
156 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA