Siemens SINAMICS S200 - Important Product Information; Intended Use

1.5 Important product information
1.5.1 Intended use
Requir
ement
WARNING
Death or serious injury if not used as intended
Not using as intended can result in hazardous s
tates.
• Carefully observe the description of intended use.
WARNING
Incorrect use of the motor
Incorrect use of
the motor may cause death, serious injury (crushing) and/or property damage.
• Carefully observe the description of intended use.
• Do not use the motors in hazardous areas (where there is a risk of explosion), if the motors
have not been expressly released and authorized for these types of applications. Carefully
observe any special supplementary notes that may be attached.
• Make sure that the conditions at the location of use comply with all the rating plate data.
• Make sure that the conditions at the location of use comply with the conditions speci󹪝ed in
this documentation. When necessary, take into account deviations regarding approvals or
country-speci󹪝c regulations.
Note
It cannot be guaranteed that EMC emis
sion limits are complied with if the products are
connected to an isolated line supply grounded through a high ohmic connection or a line supply
with grounded line conductor.
• Draw-up an EMC plan to comply with the EMC requirements of the intended application.
Description
The products described
in this manual, together with software, accessories and options, form an
electric drive to supply low-voltage AC motors.
The products are professional equipment for stationary indoor use in industrial, light-
industrial, and commercial applications and are intended for supply from non-public
(industrial) low-voltage line supplies. The products are not intended for use in residential
areas and are not intended for supply from public low-voltage networks.
The products must be properly transported and stored and must be installed, commissioned
and maintained by professionals who have adequate knowledge to implement the safety,
cybersecurity and EMC measures in accordance with the speci󹪝cations described in this
manual and with recognized state-of-the-art engineering practice.
Introduction
1.5Important product information
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
18 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA