Siemens SINAMICS S200 - Restoring Data from an Encrypted Backup File

12.1.3.3 Restoring data from an encrypted backup 󹪝le
Requirement
• You have an encrypted backup 󹪝le of the source converter on your operating unit.
• Con󹪝gured drive password:
– You know the drive password of the source converter with which the drive data in the
backup 󹪝le were encrypted.
– You know the drive password of the target converter.
Only applicable if the drive password of the target converter deviates from the drive
password of the source converter.
• Rights required for active user management (UMAC):
– "Create backup or load drive data to Startdrive"
Procedure
1. Call menu "Backup and restore" in the web server.
2. Navigate to the "Restore drive data from backup 󹪝le" area.
3. Use the "Click to select 󹪝le, or drag and drop 󹪝le here" button to select the backup 󹪝le.
4. To restore the drive data, proceed as described below depending on the speci󹪝c application.
This step is included in the following diagrams as step 3.
Corrective maintenance
12.1Service and maintenance for the converter
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
490 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA