Siemens SINAMICS S200 - Page 493

• Scenario 1: A drive passw
ord is con󹪝gured in the source converter. On the other hand,
function "Drive data encryption" had been previously de-activated in the target converter.
1
2 3
$SFBUFCBDLVQ꫼MF
3FTUPSFESJWFEBUB
%SJWFQBTTXPSEGPSDPOWFSUFS"
$POWFSUFS"
$POWFSUFS#
$POWFSUFS#
୫3FQMBDFDPOWFSUFS"
ࡒ#






– Click on "Restore".
A dialog to enter the password opens.
– Enter the drive password of the source converter.
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
Function "Drive data encryption" is activated. The drive password of the source converter
is transferred to the target converter.
• Scenario 2: The same drive password is con󹪝gured in the source and target converters.
1 2 3
$SFBUFCBDLVQ꫼MF3FTUPSFESJWFEBUB
%SJWFQBTTXPSEGPSDPOWFSUFST"BOE#
$POWFSUFS"$POWFSUFS#$POWFSUFS#
୫3FQMBDFDPOWFSUFS"
ࡒ#







– Click on "Restore".
A dialog to enter the passw
ord opens.
– Enter the drive password of the target converter.
A dialog to enter the password opens.
Corrective maintenance
12.1Service and maintenance for the converter
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 491