Siemens SINAMICS S200 - Directives, Standards and Certificates for the MOTION-CONNECT Cable

Motor requirements As of the implementation date of the standard, all a󹪜ected motor
s must
be provided with the "China Energy Label".
A󹪜ected Siemens products A󹪜ected Siemens motor
s are subject to the requirements of standard
GB30253-2013: SIMOTICS S-1FL2 servo motors.

)/$)
Figure3-13 Example of the China Energy Label
The article number ① stated on the China Ener
gy Label corresponds to the 󹪝rst 11 digits of
the article number of the SIMOTICS S-1FL2 motor.
Certi󹪝cates for download
You can 󹪝nd all relevant certi󹪝cates for download on the Internet:
Certi󹪝cates (https://support.industry.siemens.com/cs/ww/en/ps/29685/cert)
3.5.3 Directives, st
andards and certi󹪝cates for the MOTION-CONNECT cable
The following directives and standards are relevant for the MOTION-CONNECT cables:
European Low Voltage Directive
The MOTION-CONNECT cables ful󹪝ll the requirements stipulated in the Low-Voltage Directive
2014/35/EU, if they are covered by the application area of this directive.
European Machinery Directive
The MOTION-CONNECT cables ful󹪝ll the requirements stipulated in the Machinery Directive
2006/42/EC, if they are covered by the application area of this directive.
However, the use of the converters and motors in a typical machine application has been
fully assessed for compliance with the main regulations in this directive concerning health
and safety.
European RoHS Directive
The MOTION-CONNECT cables comply with Directive 2011/65/EU regarding limiting the use
of certain hazardous substances.
European EMC Directive
The compliance of the MOTION-CONNECT cables with the regulations of the Directive
2014/30/EU has been veri󹪝ed through full compliance with the IEC/EN 61800-3.
Description
3.5Directives and standards
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
72 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA