4. Remove the blanking plug from R1 and insert it into R2.
5. Connect the ext
ernal braking resistor cable to terminals DCP and R1 as shown below:
More information
For more information about cable req
uirements, see Section "Cables and connectors
(Page124)".
For more information about assembling cable terminals, see Section "Assembling cables
(Page734)".
Connecting
6.6Connecting the braking resistor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
144 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
To Next Page
Loading...
