Siemens SINAMICS S200 - Page 238

The following signals are assigned to the analog outputs by default.
Table 9-7 Default signals of analog outputs
Analog output Paramet
er Default signal
AO0 c0771[0] Actual speed smoothed
AO1 c0771[1] Torque actual value
S200 PTI uses a scaling characteristic to convert the value range -100%...100% of the
internal signal to the selected v
oltage range. The two points (x1, y1) and (x2, y2) de󹪝ne the
scaling characteristic.

9
9ROWDJHRXWSXW99
S 
[
 
S
\ 
S
[ 
S
\ 
S
More information
For more information about wiring analog outputs, see Section "Connecting t
he inputs and
outputs (Page147)".
Parameters
The following list includes the parameters of the "Analog outputs" function.
Number Name Unit
r0062 Speed setpoint after the 󹪝lter [rpm]
r0063 Speed actual value smoothed [rpm]
r0070 A
ctual DC link voltage [V]
r0079[0...1] Torque setpoint total [Nm]
r0080 Torque actual value [Nm]
c0771[0...1] CU analog outputs signal 
p29342 Reference frequency assigned to pulse input frequency 
p29343 Reference frequency assigned to remaining number of pulses 
r29350 Pulse input frequency 
r29351 Remaining number of pulses 
Functions
9.3Inputs/outputs
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
236 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA