Siemens SINAMICS S200 - Page 463

Message value: %1
Component: Power Unit
Response: OFF2
Acknowledgment: IMMEDIATELY
Cause: A checksum error (CRC error) has occurred for the power unit.
Remedy: - Carry out a POWER ON (switc
h-o󹪜/switch-on) for all components.
- U
pgrade 󹪝rmware to later version.
- Contact Technical Support.
F30805 Power unit: EEPROM checksum error
Message class: Hardware/software error (1)
Message value: %1
Component: Power Unit
Response: OFF2
Acknowledgment: IMMEDIATELY
Cause: Internal parameter data is corrupted.
F
ault value (r0949, interpre
t hexadecimal):
01: EEPROM access error.
02: Too many blocks in the EEPROM.
Remedy: Replace the module.
F30809 Power unit: Switching information not valid
Message class: Hardware/software error (1)
Message value: -
Component: Power Unit
Response: OFF2
Acknowledgment: IMMEDIATELY
Cause: For 3P gating unit, the following applies:
The las
t switching status w
ord in the setpoint telegram is identi󹪝ed by the end ID. Such an end ID was not found.
Remedy: - Carry out a POWER ON (switch-o󹪜/switch-on) for all components.
- U
pgrade 󹪝rmware to later version.
- Contact Technical Support.
F30810 Power unit: Watchdog timer expired
Message class: Hardware/software error (1)
Message value: -
Component: Power Unit
Response: OFF2
Acknowledgment: IMMEDIATELY
Cause: The watchdog timer has expired. This can only be caused by a fatal software error.
Remedy: - Carry out a POWER ON (switc
h-o󹪜/switc
h-on) f
or all com
ponents.
- U
pgrade 󹪝rmware to later version.
- Contact Technical Support.
F30815 Power unit: Processor clock signal error
Message class: Hardware/software error (1)
Message value: -
Component: Power Unit
Response: OFF2
System messages
11.3Faults and alarms
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 461