Siemens SINAMICS S200 - Page 469

Acknowledgment: IMMEDIATELY
Cause: Communications error.
Er
ror cause:
11 (= 0B hex):
Synchr
onization error during alternating cyclic data transfer.
Note regarding the message value:
The individual information is coded as follows in the message value (r0949/r2124):
0000yyxx hex: yy = component number, xx = error cause
Remedy: Carry out a POWER ON (switch-o󹪜/switch-on).
F30896 Po
wer unit (CU): Inconsistent component properties
Message class: Internal (DRIVE-CLiQ) communication error (12)
Message value: Component number: %1
Component: Power Unit
Response: OFF2
Acknowledgment: IMMEDIATELY
Explanation of the
mes
sag
e v
alue:
F
or %1
 Com
ponent in target topology
Cause: The properties of the component (power unit), speci󹪝ed
by the
fault value, have changed in an incompatible fashion with
respect to the properties when running up.
Fault value (r0949, interpret decimal):
Component number.
Remedy: - Carry out a POWER ON.
F30899 Power unit: Unknown fault
Message class: Power electronics faulted (5)
Message value: New message: %1
Component: Power Unit
Response: NONE
Acknowledgment: IMMEDIATELY
Cause: A fault occurred on the power unit, which cannot be interpreted by the converter 󹪝rm
ware.
This can occur if the 󹪝rmware on this component is more recent than the converter 󹪝rmware.
Fault value (r0949, interpret decimal):
Fault number.
Note:
If required, the signi󹪝cance of this new fault can be read about in a more recent description of the converter.
Remedy: - Replace the 󹪝rmware on the po
wer unit by an older 󹪝rmware version.
- Upgrade the converter 󹪝rmware.
F30903 Power unit: I2C bus error occurred
Message class: Hardware/software error (1)
Message value: %1
Component: Power Unit
Response: NONE
Acknowledgment: IMMEDIATELY
System messages
11.3Faults and alarms
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 467