Siemens SINAMICS S200 - Page 500

Replacing the motor with a motor with another article number
If you are using a di󹪜erent mo
tor type, after performing the three steps above, you must also
carry out the following steps:
1. Reset the converter to factory settings.
You can 󹪝nd more information in Section "Restoring the converter to factory settings".
2. Commission the converter. You can 󹪝nd more information in the following sections:
"Commissioning (web server) (Page165)"
"Series commissioning (Page221)"
Result
You have now replaced the motor.
Corrective maintenance
12.2Service and maintenance for the motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
498 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA