Note
The text files must be saved in the same way as the project files.
For example:
[System user directory]
/lng/[Text file]
[System user directory]
/proj/[Configuration file]
alsc.txt Language-dependent texts for the Siemens standard cycles
almc.txt Language-dependent texts for the Siemens measuring cycles
The text files used during program runtime are specified in the easyscreen.ini file:
[LANGUAGEFILES]
LngFile03 = user.txt ;->user<_xxx>.txt (e.g.: user_eng.txt)
In this instance, the user.txt file has been chosen as an example of a text file. The name can
always be freely selected. Depending on the language of the texts within the file, the relevant
language code must be added using the following syntax. An underscore followed by the
relevant language identifier is added after the name e.g. user_eng.txt.
Note
You must not use LngFile01 and LngFile02 for user texts because they are already assigned
in the standard easyscreen.ini.
See also
List of language codes used in file names (Page 296)
Mask-specific language files
In order to avoid overlaps for the number ranges used in the language files, only certain
language files can be used in a specific mask.
This is the reason that the language files to be used are listed in the mask definition line,
separated by a comma. The file listed at the last location has the highest priority (analogous
to the logic in easyscreen.ini).
All of the language-dependent texts used in the mask are predominantly searched for in these
language files. If the text is not found in these, then a search is made in text files configured
in easyscreen.ini.
Dialogs
4.2 Defining softkey menus
SINUMERIK Integrate Run MyScreens (BE2)
68 Programming Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
