6.13 Starting up the replacement SSD
Information on the replacement or installation of an SSD can be found in the hardware
documentation for your PC system:
● SINUMERIK PCU 50.5
– Manual SINUMERIK 840D sl Operator Components and Networking
● SIMATIC IPC
– SIMATIC IPC627 operating instructions
– SIMATIC IPC427 operating instructions
Note
Troubleshooting if reading in of the disk image fails
If data transfer is interrupted during the reading process, there will be no executable operating
system available on the Siemens PC system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in
again.
See also
Network settings (Page 10)
Restore a disk image of the SSD (Page 130)
Backing up and restoring data
6.13 Starting up the replacement SSD
PCU Base Software (IM10)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 153
To Next Page
Loading...
Need help?
General
