SD55482 $SCS_DRILL_TAPPING_SET_GG21[0] Setting tapping G group 21:
Acceleration behavior
= 0 Acceleration behavior as before the cycle call (default value).
= 1 SOFT
= 2 BRISK
= 3 DRIVE
SD55483 $SCS_DRILL_TAPPING_SET_GG24[0] Setting tapping G group 24:
Precontrol
= 0 Precontrol, the same as before the cycle call (default value).
= 1 FFWON
= 2 FFWOF
Tapping (CYCLE84)
SD55484 $SCS_DRILL_TAPPING_SET_MC[0] Spindle operation for MCALL
= 0 For MCALL, reactivate spindle operation (default value).
= 1 For MCALL, remain in position controlled spindle operation.
21.3 Manufacturer cycles
21.3.1 Manufacturer cycles
The following cycles are also available in the cycle package for individual adaptation:
CUST_TECHCYC.SPF Manufacturer cycle for the adaptation of technology cycles.
CUST_800.SPF Manufacturer cycle for the adaptation of the swivel plane and the swivel
tool functions (CYCLE800), see Chapter "Manufacturer cycle
CUST_800.SPF (Page 589)".
CUST_832.SPF Manufacturer cycle for the adaptation of the high-speed settings function
(CYCLE832)", see Chapter Manufacturer cycle CUST_832.SPF
(Page 614)".
CUST_MEACYC.SPF
Manufacturer cycle for the adaptation of the measuring functions, see
Chapter "Manufacturer and user cycle CUST_MEACYC.SPF
(Page 620)".
CUST_MEAPROT.SPF Manufacturer cycle and user cycle for the adaptation of the log form and
content, see Chapter "Manufacturer and user cycle CUST_MEAP‐
ROT.SPF (Page 650)".
Technologies and cycles
21.3 Manufacturer cycles
SINUMERIK Operate (IM9)
510 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
