EasyManuals Logo

Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Siemens SINUMERIK ONE MCP 2400.4c
1734 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1379 background imageLoading...
Page #1379 background image
2.5.20 usb (connect device)
Description
Preconditions:
Hardware: TCU 30.3
Software: If a USB device is to be used, which requires additional drivers or software, then
these must be available on the NCU.
Syntax: sc usb attach|export|unexport SERVER BUSID
sc usb detach PORT
sc usb showdevs SERVER
sc usb status
Alternative names: ---
Authorization level: None
Using command "sc usb", any USB devices, with the exception of hubs and data storage
media, which are connected to a TCU can be made available on an NCU.
For parameter SERVER (TCU, whose devices are to be used), symbolic host names (e.g.
TCU1) - as well as also IP addresses (e.g. 192.168.214.10) – can be specified.
Examples
Listing devices connected to TCU1:
# sc usb showdevs TCU1
0bf8:100c
Exporting devices from TCU1:
# sc usb export TCU1 1-2.1
In the list, this device is marked as being exported:
# sc usb showdevs TCU1
0bf8:100c
[exported]
Attaching the device to the NCU:
# sc usb attach TCU1 1-2.1
The device is listed in the local status of the NCU:
# sc usb status
Port 00: Port in Use
TCU1:1-2.1
Configuring the system
2.5 Description of the actions
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 61

Table of Contents

Other manuals for Siemens SINUMERIK ONE MCP 2400.4c

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK ONE MCP 2400.4c and is the answer not in the manual?

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK ONE MCP 2400.4c
CategoryControl Systems
LanguageEnglish

Related product manuals