C.3 XML commands
C.3.1 Overview
The scene description file (extension .xml) is required so that the X3D Viewer can access the
graphics. In the scene description file, you assign the scene names that are called from the
configuration to the times in the .x3d file (time sensor) at which the graphics are positioned.
C.3.2 Structure of the scene description file
The structure of the scene description file is shown below together with an explanation of the
relevant XML commands:
Design and description
<!-- Treatment of the plane-dependent texts for turning -->
<TextPlane plane="G18_ZXY" />
Description
<TextPlane plane="G18_ZXY" /> Treatment of the plane-dependent texts (axis
names) specifically for turning. If, for example,
a text with the identifier "Z" is used (for G18 first
geometry axis), the corresponding geometry
axis identifier of the control will be shown in the
help screen (for example, "Z").
<!--Text alignment -->
<TextPosition center='true' />
Description
<TextPosition center='true' /> Marking that the texts are centered. This is rel‐
evant to the display of the texts in rotated
screens. We recommend using this setting.
<!--Adapting the tool speed -->
<ToolSpeedFactors planeSpeedFactor="0.4" rapidSpeedFactor="0.7"
reducedSpeedFac¬tor="1.0"/>
Animated elements
C.3 XML commands
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1 313
To Next Page
Loading...
Need help?
General
