B.2 Tips for debugging
● Use the DEBUG() function for diagnostic purposes. When the DEBUG() function is called,
the transferred string is written to the easyscreen_log.txt file. The output of information in
the dialog line by the DLGL() function can also be helpful.
However, after completion of the screen development, this function should be removed
again for performance reasons or commented out.
● The easyscreen_log.txt file should have no entries after the development of a screen is
completed.
Tips and tricks
B.2 Tips for debugging
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1 301
To Next Page
Loading...
Need help?
General
