SNMPLocation
This string is used for the standard OID SNMPv2-MIB::sysLocation. It is possible to specify a
location here, which can be subsequently called with an SNMP client.
Value: Any character string
Default: Empty
SNMPContact
This string is used for the standard OID SNMPv2-MIB::sysContact. It is possible to specify a
contact address here, which can be subsequently called with an SNMP client.
Value: Any character string
Default: Empty
SNMPAutLocation
This string is used for the Siemens-specific OID
automationSystemIdent.automationLocationTag. It is possible to specify an additional location
here, which can be subsequently called with an SNMP client. This is similar to SNMPLocation
in terms of the MIB description, although it is intended for entries relating to automation.
Value: Any character string
Default: Empty
SNMPFunction
This string is used for the Siemens-specific OID
automationSystemIdent.automationFunctionTag. It is possible to specify a function
designation here, which can be subsequently called with an SNMP client.
Value: Any character string
Default: Empty
SNMPStation
This string is used for the SINUMERIK-specific OID
mcSinumerikMIB.mcSinumerikMiscStation. The value is the name of a station to which the
device belongs. Devices with the same station name are therefore identified as being
contiguous.
Value: Any character string
Default: Empty
Configuring the system
2.3 Configuration file "basesys.ini"
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 23
To Next Page
Loading...
Need help?
General
