; specifically '_' or '.' are forbidden!
;ExternalIP=210.210.210.210
;ExternalNetMask=255.255.255.0
;Gateway=210.210.210.1
;Nameservers=210.210.210.1 210.210.210.2
;Timeservers=210.210.210.3
;Hostname=somename
;Domain=example.com
; If ExternalIP is empty (default), DHCP is used with the following
; ClientID the default is "@MAC" to use the MAC address,
; alternatives are "@NAME" to use the hostname (Hostname above),
; "@CFID" to use the ID of the CF card if one is available
; (like on X120), or any other arbitrary string
;DHCPClientID=@MAC
[InternalInterface]
; If DisableSysNet is set to 1, the whole interface will
; be disabled
;DisableSysNet=1
; With InternalIP and InternalNetMask (both must be set together),
; you can change the address on the internal/TCU/automation/system
net.
;InternalIP=192.168.214.1
;InternalNetMask=255.255.255.0
; These two can define an alias IP for X120.
;InternalIP_Alias=192.168.216.1
;InternalNetMask_Alias=255.255.255.0
; This defines a "name of station" for ProfiNet (ERTEC interface)
; for use with DCP, default is the normal hostname.
; Please be careful if a PN-Name can also be set by other means,
; for example by NCU-Link. Usually it is not needed to define
Configuring the system
2.3 Configuration file "basesys.ini"
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 31
To Next Page
Loading...
Need help?
General
