Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Commissioning the system
1.4 BIOS settings for PCU 50.3
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
35
Hardware options
Fan control
Enabled
CRT/LCD selection
Simultan. Auto
Menu: Advanced
System parameters
Default settings
Own entries
Installed O/S
Other
Reset configuration data
No
Legacy USB support
Disabled
USB controller restart
Enabled
I/O Device Configuration
Internal COM 1
Enabled
Base I/O address
3F8
Interrupt
IRQ 4
PCI Configuration
PCI device slot 1
Option ROM scan
Enabled
Enable master
Enabled
Latency timer
Default
PCI device slot 2
Option ROM scan
Enabled
Enable master Enabled
Latency timer
Default
SATA/PATA Configuration
PATA Controller: Enabled
SATA Controller mode
Enhanced
AHCI Configuration
Disabled
RAID support
Disabled
Menu: Security
System parameters
Default settings
Own entries
Supervisor password is
Disabled
User password is
Disabled
Set user password
Enter
Set supervisor password
Enter

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English