Configuring the system
2.4 Configuring the SITOP UPS module for use with the PCU Base Software
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
63
Information about available SITOP UPS modules is given in the catalog or in the Internet:
● Catalog KT 10.1 Power supply SITOP
● SIEMENS Industry Mall > 24 V DC Uninterruptible Power Supplies
(https://eb.automation.siemens.com/mall/en/US/Catalog/Products/7010117)
Note
Information about the test environment for machine OEMs
The functionality has been tested in the standard configuration with the PCU base soft
ware.
-on or OEM software components, you must check the shutdown
procedure of the entire system and adapt the factory setting (180 seconds).
Parameterizing a delay time for quitting the HMI software (Page 67)
To Next Page
Loading...
Need help?
General
