7.2 Evaluation of the diagnostic displays H1/H2........................................................................156
7.3 Setting of the operating mode during run-up........................................................................158
7.3.1 Service switch (PCU 50.5)...................................................................................................158
7.3.2 Possible operating modes....................................................................................................159
7.3.3 Software-side setting (SIMATIC IPC)...................................................................................159
7.4 Switching to the Service Desktop during autostart / autologon operation............................160
7.5 Configuring the SINUMERIK power up screen....................................................................162
7.6 Remote access....................................................................................................................165
7.6.1 Overview..............................................................................................................................165
7.6.2 Searching for devices in the system network.......................................................................165
7.6.3 Display of accessible stations in SINUMERIK Operate.......................................................165
7.6.4 Remote access to the PCU for operation and maintenance................................................166
7.6.5 Setting up and using SSH....................................................................................................169
7.6.6 Encryption via SSH protocol................................................................................................170
Index.........................................................................................................................................................171
Table of contents
PCU Base Software (IM10)
6 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1