<!-- **** Priority tool, own parameter *** -->
<!-- **** Display OEM tool parameter 2 bit 0 *** -->
<Item value="PriorTool" type="QString" />
</TOOLTYPE_ALL>
</COLUMN7>
<!-- **** Column 8 *** -->
<COLUMN8>
<!-- **** For all tool types *** -->
<TOOLTYPE_ALL>
<!-- **** Display OEM cutting edge parameter 1 *** -->
<Item value="EdgeUser_1" type="QString" />
</TOOLTYPE_ALL>
</COLUMN8>
</SlTmTooloemForm>
</LISTCONFIGURATION>
<!-- **** Identifier for the configuration of own parameter *** -->
<!-- **** Change OEM tool parameter 1 *** -->
<ToolUser_1>
<!-- **** Column width *** -->
<Width value="36" type="int" />
<!-- **** Type change to unsigned integer *** -->
<DisplayMode value="UnsignedIntegerMode" type="QString" />
</ToolUser_1>
<!-- **** Identifier of own parameter *** -->
<!-- **** Priority tool *** -->
<!-- ** New parameter is based on OEM tool parameter 2**-->
<Base value="ToolUser_2" type="QString" />
<!-- **** Bit 0 is evaluated *** -->
<BitMask value="1" type="int" />
<!-- **** Text identifier of the headline *** -->
<HeadLine value="TMO_HL_PRIOR_TOOL" type="QString" />
<!-- **** Text identifier of the tooltip *** -->
<ToolTip value="TMO_TT_PRIOR_TOOL" type="QString" />
<!-- **** Column width *** -->
<!-- **** Recommended widths 640x480 - 19 pixels *** -->
<!-- **** 800x600 - 21, 1024x768 - 17 *** -->
<Width value="19" type="int" />
<!-- **** Display item of the parameter *** -->
<ItemType value="CheckBox" type="QString" />
</PriorTool>
</PARAMETERCONFIGURATION>
</CONFIGURATION>
Tool management
12.4 Examples
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 235
To Next Page
Loading...
Need help?
General
