Page 20 of 52 7482255 Rev 01 Siemens
October 2002
Installing the Color Printer and the VCR
6. Hold the bumper, and remove the entire front cover from the G50 or the
G60 S.
7. Pry off six screw caps from the top cover, then remove six M4 X 10 flat head
screws and washers as shown in Figure 4-17: Do not remove the two sets
of screws located in the middle.
8. Pull out the top cover from the system as shown in Figure 4-17.
9. Disconnect all of the cables from the rear side of P91W as shown in
Figure 4-10.
10. Unscrew the two M3 X 8 binding head screws and external lock washers
from bracket F, then remove the P91W and its mounting plate from the
OEM bay.
11. Unscrew the four M4 X 8 binding head screws and external lock washers
that attach the OEM bay to the G50 or the G60 S.
12. Remove the OEM bay from the G50 or the G60 S.
13. Detach the plastic bag from the OEM bay, and remove the four M3 X 8 flat
head screws provided in this bag.
14. Remove the two S-type brackets and the separator from the OEM bay by
unscrewing the four M3 X 8 flat head screws that attach them.
15. Turn the SVO-9500 upside down.
16. With the bottom of the SVO-9500 facing upward, place the SVO-9500 on a
padded or protected platform of 25 mm (1 inch) or higher.
17. Invert the OEM bay and place it over the bottom surface of the SVO-9500.
18. Using the four M3 X 8 flat head screws removed from the plastic bag,
secure the OEM bay to the SVO-9500 by installing the four screws through
the holes marked with the character S.
19. Return the inverted SVO-9500 and the attached OEM bay to their original
upright position.
20. Place the OEM bay, with the SVO-9500 attached, in its original position in
the G50 or the G60 S, but do not position the OEM bay all the way toward
the rear; confirm that enough space remains between the SVO-9500 and
the interface panel to re-establish cable connections between them.
21. Reinstall the mounting hardware that was initially removed from the OEM
bay.
22. Re-install the P91W, still attached to its mounting plate, in the OEM bay.
23. Fasten the front edge of the mounting plate to the bracket F, using two
M3 X 8 binding head screws with external lock washers that were removed.
24. At the SVO-9500, position the S VIDEO IN IMPEDANCE switch to 75 _/
ON.
25. Position the number 3 and the number 5 DIP switches in the On position.
26. At the P91W, position the number 1 DIP switch in the On position.
To Next Page
Loading...
