6.2 PRELIMINARY OPERATIONS
Procedure:
1) Place the key-cutting machine on a work bench.
2) Connect the power lead to the mains (Ch.3.3).
3) Make sure the emergency button (K - Fig. 6) is disabled.
4) Check that the USB PEN is in its special holder.
5) Turn the machine on with the master switch (Z - Fig. 6) on the back.
-
to check or edit the machine parameters, go to the menu (Ch.6.9).
-
set the required measuring unit (default is MILLIMETRES)
6) When the machine is switched on the following MAIN SCREEN appears on the display.
The main screen shows the Function icons as well as the following data:
• Name of key-cutting machine
• Machine serial number
• SW version: machine program version
• DB version: Series database version on machine
• MENU wording (ashing)
• Date
• Time
•
Machine in UTP mode (Unlimited Token Plan)
GREEN:
days of use exceed the minimum warning point set in the
Options=> UTP menu (Ch.6.14.2)
YELLOW:
days of use are below the minimum warning point set in the
Options=> UTP menu (Ch.6.14.2)
RED:
days of use have expired or are about to expire (Ch.6.14.2)
-> OFF Press button 2 to disable the USB PEN
-> ON Press button 1 to enable the USB PEN
Operating manual TRIAX PRO
Copyright Silca 2016
28
To Next Page
Loading...
