8 CLEANING AND MAINTENANCE
8.1 CLEANING
• Do not clean the machine with alcohol.
• Keep the working parts of the machine as clean as possible, removing swarf with a brush.
• Never use compressed air to clear swarf off the work area; it could cause offcuts to clog the working
parts.
• Never use oily products or solvents to clean the painted surfaces, clamps and electric and electronic
connection points.
8.2 MAINTENANCE
NOTE: in the event of repairs or replacement of parts for maintenance, the “CE” mark is guaranteed only if
original spare parts provided by the manufacturer are used.
The TRIAX PRO key-cutting machine does not need special maintenance but it is good practice to check and
if necessary replace parts subjected to wear and substitute electric/electronic parts (fuses, circuit boards, etc.)
when they are not working properly.
Parts can be replaced by the operator observing the instructions.
NOTE: For normal maintenance of burnished mechanical parts we suggest using lubricants or protective
products such as WD40 or similar. Do not apply them to the parts used for electric contact (clamps, decoders,
cutters, calibration templates...). Do not let the product come into contact with the electronic parts.
Before starting any type of maintenance (checks or replacements) read the following warnings:
• Do not carry out any maintenance operations with the machine on
• Always disconnect the power lead
• Follow the instructions in the manual to the letter
• Use original spare parts (see “spare parts sheet” provided with the machine).
Operating manual TRIAX PRO
Copyright Silca 2016
80
To Next Page
Loading...
