Silca Triax Pro - Oem Mode

6.14.6 OEM MODE [PAGE 5/5]
The display shows: OEM mode
Option for OEM users who cut large quantities of keys using
the same clamp and cutter.
To work more rapidly (key cutting) the user may vary the
frequency of checking the cutter on the clamp calibration
plate. In the standard mode this check takes place for each
single key to be cut.
Enabling OEM mode:
arrow keys to change YES/NO. ENTER to conrm.
Plate contact every xxx keys cut: enter a number of keys
(checking frequency) in the special eld (1 to max. 999).
Note: we advise OEM users to check the contents of
Ch.6.5.2 USER PARAMETERS- Change cutting speed.
F3 to save.
F3
Operating manual TRIAX PRO
Copyright Silca 2016
71