Silca Triax Pro - Triax Pro Messages; Warnings and Alarms

7 TRIAX PRO MESSAGES
7.1 WARNINGS
The key cannot be cut if the combination entered is not complete.
This is a feature of keys for vehicles.
ATTENTION
Cung combinaon not
complete!
Please enter all cuts.
To use the TRACER TOWER to decode it must be enabled. Check
the setting in the OPTIONS menu and choose YES.
ATTENTION
TRACER TOWER non abilitato!
Vericare impostazione nel
menu OPZIONI
The selected series can be used only by entering a valid indirect
code. The cut insertion function is not accessible.
ATTENTION
An indirect code is needed to
access the series.
Do you want to proceed?
No=STOP Yes=ENTER
The messages warn the user that to cut a key with this series a
different clamp must be tted, or the clamp involved must be
calibrated. This operation must be performed before using the
series. Press ENTER to consult the series data, but without cutting
the keys.
ATTENTION
The jaw is not calibrated!
By pressing ENTER you can only
consult the cards data
ATTENTION
In order to use the series the
jaw needs to be removed.
Pressing ENTER you can only
consult the cards data
The message appears when data is loaded onto the machine by a
USB-PEN older than those in the machine memory.
ATTENTION
An older data version has been
detected on the USB PEN:
do you sll want to connue?
No=STOP Yes=ENTER
The message indicates that neither SILCA or the user has
created
an engraving model for the key blank selected.
ATTENTION
No engraving model has been
created for the selected key
blank
ATTENTION
Models have been modied by
the User: by proceeding all
changes will be lost
STOP=Cancel ENTER=Connue
Operating manual TRIAX PRO
Copyright Silca 2016
73