Silca Triax Pro - Page 80

The procedure for loading user engraving models from a USB
PEN overwrites all the user models stored on the machine.
Editing of the text or the text position will be lost.
To keep the edited templates stored on the machine use the
SKP program or the Free Engraving program provided with the
machine.
ATTENTION
This operaon will overwrite
all User models previously
saved in the machines memory.
Not to lose any changes made
to the User templates, please
use the Silca Key Programs to
transfer the engraving models.
The text inserted on the LINE shown at the end of the message is
outside the set rectangle (or area). Reduce the number of characters
or increase the width of the rectangle
ATTENTION
Entered text exceeds maximum
area that is reserved for
engraving!
See row:
The OPTIONS menu can be used to choose which makes of
cylinders to search through for a lock system (SSN) by key blank,
code, description, etc. If by mistake all the makes are disabled the
search will give no results
ATTENTION
Select at least one MFG !
[ENTER]
The procedure in the ENGRAVING function for positioning the line
of text has not been successfully completed. Please repeat.
ATTENTION
Text tracking area posion has
not been acquired
[ENTER] to connue
Message for the OEM version without tracer point U102 for dimple
keys
ATTENTION
The Tracer Tower is missing
tracer U102
See operang manual.
A new contact is required between the cutter and calibration plate.
Carefully clean the calibration plate and cutter before proceeding
with cutting.
ATTENTION
Start cuer gauging!
Carefully clean seng plate
and cuer before proceeding.
STOP=Cancel START=Connue
Operating manual TRIAX PRO
Copyright Silca 2016
74