Silca Triax Pro - Usb Pen Not Connected or Without Required Data; Messages Linked to Presence or Use of Motorized Clamp

7.1.1 USB PEN NOT CONNECTED OR WITHOUT REQUIRED DATA
The required data have not been found on the USB PEN; check that
the pen is connected and contains the data. If the contents of the
USB PEN have been deleted by mistake, use the WinTransfer/SRS
program to re-load the data by means of the special function.
ATTENTION
La tabella di codici
non è stata trovata:
vericare che la USB PEN
sia collegata e accesa
ATTENTION
Da non trova o
USB PEN non inserita
7.1.2 MESSAGES LINKED TO PRESENCE OR USE OF MOTORIZED CLAMP
IMPORTANT
To install a motorized clamp, for example the R13 tilting clamp,
follow the instructions on the display.
To proceed with the selected operation you must:
1) Install the motorized clamp
2) Connect the clamp to the serial port (M) for axis B.
JAW INSTALLATION R13
To proceed with the selected opera
-
on you must:
1. Install the motorized jaw
2. Connect the jaw
ATTENTION
Connecng or disconnecng
the motorized jaw while the
machine is moving can damage
the electronic board.!
ATTENTION: connecting or disconnecting the motorized clamp with the machine in motion may damage
the electronic circuit board.
Operating manual TRIAX PRO
Copyright Silca 2016
75