Simrad SX90 - INSTALLATION REV C - How to Change the Interface Settings

Interfacingperipheralequipment
Table5Defaultinterfacesettings(cont’d.)
Sensor
TypePortBaudrateTalker
Stabilisation
sensor
————
WeatherWind
—
4800None
Howtochangetheinterfacesettings
Toitbecomesnecessarytochangeanyoftheinterfacesettings,
observethefollowingprocedure.
HowtoopentheInstallationmenu
1OpentheSetupmenu.
2ClicktheTestbuttontoopentheSystemTestmenu.
3ClicktheInstallationMenubutton.
4ObservethattheInstallationmenuappearsatthetopofthe
display.
Figure52Installationmenu
Howtospecifyinterfaceparametersettingsusing
theInstallationmenu
1OpentheInstallationmenu.
2SelectI/OSetup→Sensors.
3Observethesub-menulistingalltheavailablesensors.
Figure53IOSetupmenuwithSensorssub-menu
307531/C
129