Simrad SX90 - INSTALLATION REV C - Connect the Two Cables from the Interface Unit to the Processor Unit

Cablelayoutandinterconnections
ConnectthetwocablesfromtheInterface
UnittotheProcessorUnit
Thesearetwospecialinterconnectioncablesprovidedwiththe
sonar.Bothare1,2meterslong,andconnectedpermanentlyto
theInterfaceUnitend..
•CableC14communicatesthecontrolsignalsbetweenthe
ProcessorUnitandtheInterfaceUnit.Thecableisequipped
witha37-pinfemaleDeltaconnectorontheProcessorUnit
end.Theconnectorwillonlytitsrespectivesocketinslot
J8ontherearsideoftheProcessorUnit.
•CableC15communicatestheserialinformationbetweenthe
InterfaceUnitandtheProcessorUnit.Thecableisequipped
withaspecial78–pinmalemulti-connectorintheProcessor
Unitend.Theconnectorwillonlytitsrespectivesocketin
slotJ7ontherearsideoftheProcessorUnit.
Procedure
ThesearecablesSX90/C14andSX90/C15.
1
ConnectcableC14fromtheInterfaceUnittoslotJ8
ontherearsideoftheProcessorUnit.
2
ConnectcableC15fromtheInterfaceUnittoslotJ7
ontherearsideoftheProcessorUnit.
Figure29ThecablesfromtheInterfaceUnittotheProcessorUnit
Relatedtopics
•InterfaceUnittoProcessorUnitonpage195
307531/C
77