Simrad SX90 - INSTALLATION REV C - Connect the Operating Panel Dual Cable

SimradSX90
ConnecttheOperatingPanel“Dualcable”
ThisisaspecialdualcablefromtheOperatingPaneltothe
ProcessorUnitandtheInterfaceUnit.Thiscablehasone
common15-pinconnectorleadingtotwoseparate9-pin
connectorsinthetwootherendsofthecable.Thecableis
includedinthestandarddelivery,andthecablelengthis4,5
meter.Thecableisconnectedasfollows:
•15-pinD-connector(commonend)toOperatingPanel.
•9-pinfemaleD–connectortoInterfaceUnitsocketJ4.
•9-pinmaleD–connectortoProcessorUnitslotJ2.
Procedure
ThisiscableSX90/C12.
1
ConnectthesingleendofthecabletotheD-connector
undertheOperatingPanel.
2ConnectoneendtotheD-connectorinslotJ2onthe
rearsideoftheProcessorUnit
3
ConnectthethirdendtotheD-connectorinsidethe
InterfaceUnit.
Figure28TheOperatingPanel“Dualcable”connections
Relatedtopics
•OperatingPanel“Dual”onpage213
76
307531/C