Simrad SX90 - INSTALLATION REV C - Catch Monitoring Interface Setup and Test; Radio Buoy System Interface Setup and Test

Interfacingperipheralequipment
Relatedtopics
•Trawlsysteminterfaceonpage191
•SonarandITIcommunicationonpage201
•SonarandFS20/25communicationonpage202
Catchmonitoringinterfacesetupandtest
Observethefollowingproceduretosetupandtestthecatch
monitoringsysteminterface.
1AccesstheI/OSetupmenu.
•Toaccessthismenu,seeHowtochangetheinterface
settingsonpage129.
2OntheI/OSetupmenu,selectSensors→Trawlsystem.
•Select→ITItochecktheinterfacetotheSimradITI
system
•Select→PI30tochecktheinterfacetotheSimradPI30,
PI32,PI44orPI54systems.
3ObservethattheSensorCongparameterdialogueappears
atthebottomofthemenueld.
4ChangethesettingsintheSensorCongparameterdialogue
tosuityourrequirementsfortheserialline.
5ClickClosetoexittheSensorCongparameterdialogue.
6OpentheSetupmenuonthesonar.
7ClicktheGearbuttontoaccesstheGearparameterdialogue
atthebottomofthemenueld.
8SelectoneofthePursesettings.
9ClicktheEditbuttontoaccesstheNetConguration
parameterdialogue.
10Checkthatthedifferentread-outsintheparameterdialogue
correspondstothosefromtheconnectedcatchmonitoring
system.
Relatedtopics
•Catchmonitoringsysteminterfaceonpage192
•SonarandPI44/PI54communicationonpage203
•SonarandPI30/PI32communicationonpage204
Radiobuoysysteminterfacesetupandtest
Observethefollowingproceduretosetupandtesttheradiobuoy
systeminterface.
1AccesstheI/OSetupmenu.
•Toaccessthismenu,seeHowtochangetheinterface
settingsonpage129.
307531/C
139