Simrad SX90 - INSTALLATION REV C - Installation of the Display Unit; Installation of the Operating Panel

Wheelhouseunitsinstallation
Installationofthedisplayunit
Differentdisplayunitsareavailableasoptionalequipment.For
installationandoperationofthechosendisplayunit,refertothe
manualsuppliedwiththeunit.
Installationprocedure
Toensurecorrectoperation,tickoffeveryitemwhentheaction
hasbeencarriedout.
1
Installthedisplayunitasdescribedtheapplicable
documentationprovidedwiththeunit.
Relatedtopics
•Maximumdistancesbetweentheunitsonpage56
InstallationoftheOperatingPanel
Installationprocedure
TheOperatingPanelisdesignedtoberecessedinapanel.
Toensurecorrectoperation,tickoffeveryitemwhentheaction
hasbeencarriedout.
1
MounttheOperatingPanelinanalmosthorizontal
positiontofacilitateoperationofthetrackball.
•Thenecessarymountinghardware(fourscrews,fournut
platesandfourboltcovers)aresuppliedinthestandard
delivery.
2
Drillandcutthepanelopeningasshowninthegure.
3
MounttheOperatingPanelusingthesupplied
hardware.
APositionthefournutplatesshowninthegure.
Figure20OperatingPanelcut-out
372mm
Nutplate
152mm
401.9mm
ø7x4
(CD015022M)
307531/C
57