Simrad SX90 - INSTALLATION REV C - Installation of the Beamformer Unit

Wheelhouseunitsinstallation
Figure21InstallationoftheProcessorUnit
(CD015006C)
A
B
D
C
AComputerassembly
BLockingpin
CMountingframewithshockabsorbers
DFasteningscrews
Relatedtopics
•Maximumdistancesbetweentheunitsonpage56
•MC80ProcessorUnitdimensionsonpage158
InstallationoftheBeamformerUnit
TheBeamformerUnitshouldbemountedonthedeckorshelf
insideaconsole,cabinetordesk.Itmustbemountedclosetothe
InterfaceUnit,OperatingPanelanddisplayunit.Provideenough
spaceforeasyaccesstothecablingattherearoftheunitandfor
removalofthefrontlid.
Installationprocedure
Toensurecorrectoperation,tickoffeveryitemwhentheaction
hasbeencarriedout.
1
Preparethemountinglocation.
2
Dismountthemountingframewiththeshockabsorbers
fromthecomputerbylooseningthetwofasteningscrewson
thefront,andpullthecomputerassemblyforwards.
307531/C
59