Simrad SX90 - INSTALLATION REV C - Cable Procedures

SimradSX90
Cableprocedures
Observethefollowingproceduretoperformthesonarcabling.
Notethatdetailedinformationaboutcablespecications,
terminationandconnectorsareprovidedinthereferenced
sections.AllcablesareprovidedbySimradunlessotherwise
specied.Inordertoprovideformaintenanceandtoallowfor
vibration,makesurethatsomeslackisprovidedforallcables.
Tomakesurethateachprocedureisfollowed,tickoffeachtask
afterithasbeendone.
Note
Beforeyouperformthesonarcabling,ensurethatthemains
circuitbreakerforthesonarsystemisswitchedoff.
D
o n o t mounttheexibletransducercabletotheTransceiver
Unit.Thiswillbedescribedlater .
Topics
•ConnectACmainstotheUninterruptedPowerSupplyon
page73
•ConnectthevideocablefromtheProcessorUnittothecolour
displayonpage74
•ConnecttheUSBcablefromtheOperatingPaneltothe
ProcessorUnitonpage75
•ConnecttheOperatingPanel“Dualcable”onpage76
•ConnectthetwocablesfromtheInterfaceUnittothe
ProcessorUnitonpage77
•ConnecttheProcessorUnittotheBeamformerUniton
page78
•ConnectACmainsandgroundtotheProcessorUniton
page79
•ConnectACmainsandgroundtotheBeamformerUniton
page80
•ConnectACmainstothecolourdisplayonpage81
•ConnectACmainstotheTransceiverUnitonpage82
•ConnectgroundtotheInterfaceUnitonpage83
•ConnectgroundtotheOperatingPanelonpage84
•ConnecttheBeamformerUnittotheTransceiverUniton
page85
•ConnectACmainstotheMotorControlUnitonpage86
•ConnecttheTransceiverUnittotheMotorControlUniton
page87
72
307531/C