Simrad SX90 - INSTALLATION REV C - Connect AC Mains to the Motor Control Unit; This Cable Must be Provided by the Installation Shipyard

SimradSX90
ConnectACmainstotheMotorControlUnit
Thisisaspecialmainscablefor3-phaseACmains.Itmust
beprovidedbytheinstallationshipyard.Observethecable
specications,seeACmainstoMotorControlUnitonpage207.
Procedure
ThisiscableSX90/C06.
1
Connectthe3–phaseACmainscablefromtheMotor
ControlUnittothevessel’s3-phaseACmains.
Note
Thiscablemustbeprovidedbytheinstallationshipyard.
Use4x2.5mm²cable,ensurethatthescreenisproperly
terminatedinthecablegland.
DONOTapply3–phasepowertotheMotorControlUnit
untilinstructedbytheapplicablestart-upprocedure.
Figure363–phaseACmainsconnections
Relatedtopics
•ACmainstoMotorControlUnitonpage207
86
307531/C