Simrad SX90 - INSTALLATION REV C - Connect AC Mains to the Uninterrupted Power Supply

Cablelayoutandinterconnections
•ConnectACmainstotheHeatExchangeronpage88
•ConnecttheEthernetcableforscienticoutputonpage89
•Connectcabletoexternalaudiosystemonpage89
•Transducercableonpage90
•Installationofinterfacecablestoperipheralequipmenton
page90
ConnectACmainstotheUninterrupted
PowerSupply
TherearetwoUninterruptedPowerSupply(UPS)locations;the
sonarroomandthewheelhouse.StandardcommercialACmains
cablesareused,andtheseareprovidedwiththeUninterrupted
PowerSupplyunits.IftheACmainsconnectorsonthecabledo
nott,replacethemwithasuitableconnector.
Procedure
ThesearecablesSX90/C16andSX90/C17.
1
ConnecttheUninterruptedPowerSupplyinthe
wheelhousetothevessel’sACmains.
2ConnecttheUninterruptedPowerSupplyinthesonar
roomtothevessel’sACmains.
Relatedtopics
•ACmainswithIEC320/C21onpage206
307531/C
73