Simrad SX90 - INSTALLATION REV C - Connect the Beamformer Unit to the Transceiver Unit; It Is very Important that a CAT-6 (or CAT-7) Ethernet Cable Is Used. Cables with Lower Bandwidth Capacity will Reduce the Sonar Performance

Cablelayoutandinterconnections
ConnecttheBeamformerUnittothe
TransceiverUnit
Procedure
ThisiscableSX90/C31.
1
ConnecttheEthernetcablefromtheb o t t o m Ethernet
socketonslotJ4ontherearsideoftheBeamformerUnitto
ther
i g h t EthernetsocketundertheTransceiverUnit.
Note
Thiscablemustbeprovidedbytheinstallationshipyard.
UseacommercialCAT–6cable.Werecommendthatan
additionalspareethernetcableisinstalledbetweenthe
wheelhouseandthesonarroom.
ItisveryimportantthataCAT-6(orCAT-7)Ethernetcable
isused.Cableswithlowerbandwidthcapacitywillreduce
thesonarperformance.
EachendoftheEthernetcablemustbeterminatedwith
aPhoenixContact“V ariosubRJ45Quickcon”connector.
Twooftheseconnectorsareprovidedinthesonardelivery.
Mountinginstructionsareincludedwiththeplugassembly.
Figure35BeamformerUnittoTransceiverUnitconnections
Relatedtopics
•RJ45Ethernet,straightonpage208
307531/C
85